Zhone 3920Plus Manual de Instruções Página 61

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 60
Status Branch
4-33920-A2-GH30-40 October 1998
Device Health and Status (DeviceHS)
DeviceHS provides a ‘‘snapshot of current modem alarms which are active at the time the
DeviceHS function is selected.
To access DeviceHS from the Status branch, make the following selection:
F1
Status: >
DeviceHS VF
F2
F3
Select DeviceHS.
F1
Device HS: >
Major Minor
F2
F3
If alarms are present, press the appropriate function key to view the messages associated with
these alarms (Table 4-1). If needed, press the
key to scroll to additional alarm types. If no
alarms are present, the word Normal appears on the LCD.
Table 4-1
(1 of 3)
Health and Status Messages
Type
Message Indicates
Major
Device Failure A device/self test has failed. The probable cause is a modem hardware problem
or diagnostic memory failure.
Facility Fault A severe data transport problem is occurring due to poor line conditions. No
signal or a very poor signal is being received.
Streaming DTE The modem is in an antistreaming condition. The RTS input to the modem was
held ON for a period exceeding the time selected by the RTS Antistream
configuration option. (Refer to the DTE Interface section in Chapter 5, Configure
Branch, for a description of the RTS Antistream configuration option.)
Access Security A dial access security alarm is active. (Refer to the Security section of this table
for dial access security conditions.)
External Alarm A External input A to Port 4 of the modem is in an alarm condition.
External Alarm B External input B to Port 4 of the modem is in an alarm condition.
Minor VF Threshold One or more of the analog parameter thresholds have been exceeded. The
probable cause is poor line conditions or improper threshold settings.
Thresholds may be set through the DCP or NMS commands.
DTE Alarm One or more of the DTE signals on one or more of the DTE ports are in alarm
mode. (Refer to the Port 1, 2, 3, 4 section of this table for DTE alarm conditions.)
Rate Fallback Due to poor line conditions, the modems transmit rate is below the configured
rate. (Refer to the Multiport or Singleport Leased Line and Dial Line sections in
Chapter 5, Configure Branch, for a description of configuration options affecting
rate.)
Vista de página 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 353 354

Comentários a estes Manuais

Sem comentários