Zhone MIM-4T1 Guia do Utilizador descarregar pdf (Página 4)

4 June 2005 MIM4-A2-GZ41-00

Connecting the T1 Line

A primary feature of the MIM-4T1 is loop bonding capability, though the module

can function with a single T1 connection as well.

NOTE: A MIM-4T1 must be connected with T1 provider equipment; a connection

between the MIM-4T1 and T1 subscriber equipment will not function.

Loop Bonded Connection

Using multiple T1 lines for one network connection (loop bonding ) multiplies the

speed and data passing capability of the connection. Multiple T1 lines also provide

backup should any of the lines become disabled. A MIM-4T1 can only establish

loop bonded connections with other loop bonding capable T1 provider equipment;

refer to the T1 Loop Bonding Product to Product Feature Compatibility list

(Document Number COMP-A2-GK43 ).

Procedure

1. If ferrite chokes are supplied with your MIM:

— Open a ferrite choke.

— One or two cables will fit in the ferrite choke. Make a loop at the end of

your cables and close them in the ferrite choke. Position the choke as

close as possible to the RJ48C connectors.

— Snap shut the ferrite choke.

2. Plug your T1 cables into the T1 RJ48C ports on the MIM-4T1 faceplate; the

order of connection is not important.

3. Verify all connections: the Port Lnk LEDs on the MIM-4T1 faceplate will flash

green to indicate the connections are established and operational.

04-17593

1 2 3 4 5 6 7 8 9 10

Sem comentários

Zhone MIM-4T1 Guia do Utilizador Página 4